CELLULAR NETWORK

Mobile module

5G SA Sub-6 - up to 2.1 Gbps downlink, 450 Mbps uplink

5G NSA Sub-6 - up to 2.5 Gbps downlink, 600/650 Mbps uplink

LTE - up to 1 Gbps downlink, 200 Mbps uplink

Status

Signal strength (RSSI), Attached network, IMSI, ICCID

APN

Auto APN, Customized APN

WIFI

Wireless mode

IEEE 802.11b/g/n/ac, Access Point (AP)

WiFi security

WPA2-PSK, WEP, WPA-EAP, WPA-PSK; AES-CCMP, TKIP, Auto Cipher modes, client separation

SSID

SSID stealth mode and access control based on MAC address

WiFi users

Up to 60 simultaneous connections

PHYSICAL INTERFACE

WAN

1 x WAN port (can be configured to LAN) 1000/100 Mbps, compliance with IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX

LAN

4 x LAN port, 1000/100 Mbps, compliance with IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX

The LAN ports can offer POE power to other devices, 802.3af(Option)

Serial

1-RS232, 1-RS485. 3.5 mm female socket with lock

SD Card Slot

1x Micro SD interface, up to 32G, for User Program, Data Storage and Firmware Upgrade

I/O

3.5 mm female socket with lock

2 x DI (0-30V Input), Status “0”: 0-3V, status “1”: 5-30V

3 x Relay Output (Up to 5A and 30VDC/250VAC switch)

3 x 16-bit Analog Input, supports 4-20mA current signal input, and 0-5V voltage signal input

2 x Power Output (12V output, current 1A), Built-in overcurrent protection, for external devices DC power input

GPS (Option)

Built in external GPS module

SIM

1 Standard SIM card slot,1.8 V/3 V, external SIM holder

Antenna

4 x SMA for 5G, 2 x SMA for WiFi antenna connectors

LED

3 x Signal strength LEDs, 1 x Alarm LED, 1 x Run status LED,1 x Power LED,1 x VPN status LED, 1 x WIFI LED

Reset

Reboot/Factory reset button

NETWORK

Routing

Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, RIPng, OSPF6)

Network protocols

TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, TLS, ARP, VRRP, OSPF, PPPoE, UPnP, SSH, DHCP, Telnet client, SNMP

Serial Port

MQTT, Transparent (TCP Client/Server, UDP Client/Server), Modbus Gateway (Modbus RTU to Modbus TCP)

Connection monitoring

Ping Reboot, Periodic Reboot, LCP and ICMP for link inspection

Firewall

SPI Firewall, DoS attack, VPN traversal, Access Control, Port Mapping, DMZ Mapping, Access Control List(ACL), IP-MAC binding and Clone function

DHCP

Static and dynamic IP allocation, DHCP Relay

QoS

Traffic priority queuing by source/destination, service, protocol or port

DDNS

Supported >25 service providers, others can be configured manually

Network backup

VRRP, Mobile and Wired, each of which can be used as backup, using automatic failover

SECURITY

Attack prevention

DDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention)

VLAN

Port and tag based VLAN separation

WEB filter

Blacklist for blocking out unwanted websites, whitelist for specifying allowed sites only

Access control

Flexible access control of TCP, UDP, ICMP packets, MAC address filter

VPN

OpenVPN

Multiple clients can be running simultaneously, 10 encryption methods

OpenVPN Encryption

DES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC

IPsec

IKEv1, IKEv2, supports up to 10 x VPN IPsec tunnels (instances), with 5 encryption methods (DES, 3DES, AES128, AES192, AES256)

GRE

GRE tunnel

PPTP, L2TP

Client/Server services can run simultaneously

Serial transmission

TCP/UDP server

Parameters

Port, Baud rate, Parity, Data bits, Stop bits, Flow control

TCP/UDP client

Parameters

Port, Baud rate, Parity, Data bits, Stop bits, Flow control, Heartbeat

Data center

Supported 4 server run simultaneously

MONITORING & MANAGEMENT

WEB UI

HTTP, status, configuration, FW update,troubleshoot, event log, system log, kernel log

FOTA

Firmware update from sever, automatic notification

SNMP

SNMP (v1, v2, v3)

IOT CLOUD MANAGEMENT PLATFORMS

Cloud of Things

Allows monitoring Network info, Availability

Configure

Configure parameters, Update firmware

SYSTEM CHARACTERISTICS

CPU

32-bit, ARM 880MHz, dual core

RAM

256 MB, DDR3

FLASH storage

128MB, SPI

FIRMWARE / CONFIGURATION

WEB UI

Update FW from file, check FW on cloud, configuration backup and restore

FOTA

Update FW/configuration from cloud platform

RMS

Update FW/configuration for multiple devices

Keep settings

Update FW without losing current configuration

POWER

Connector

2-pin with 3.5 mm terminal block

Input voltage range

5 – 35 VDC, reverse polarity protection, surge protection

Power consumption

< 9 W Max

PHYSICAL SPECIFICATION

Casing material

Metal housing, DIN rail mounting option

Dimensions (W x H x D)

208 x 125x 48 mm

Weight

990 g

OPERATING ENVIRONMENT

Operating temperature

-40 °C to 75 °C

Operating humidity

10% to 90% non-condensing

Ingress Protection Rating

IP30

REGULATORY & TYPE APPROVALS

Regulatory

CE, FCC, CCC

EMI IMMUNITY

Standards

Draft EN 301 489-1 V2.2.0, Draft EN 301 489-17 V3.2.0, Draft EN 301 489-52 V1.1.0
FCC 47 CFR Part 15B (2017), ANSI C63.4 (2014)

ESD

EN61000-4-2:2009

RS

EN 61000-4-3:2006 + A1:2008 + A2:2010

EFT

EN 61000-4-4:2012

Surge immunity (AC Power Line)

EN 61000-4-5:2006

Surge immunity (Ethernet ports)

EN 61000-4-5:2014, clause 7.1 of ITU-T K21

CS

EN 61000-4-6:2009

DIP

EN 61000-4-11:2004

RF

Standards

EN 300 328 V2.1.1, EN 301 511 V12.5.1, EN 301 908-1 V11.1.1, EN 301 908-2 V11.1.1, EN 301 908-13 V11.1.1
FCC 47 CFR Part 15C (2017), FCC 47 CFR Part 2 (2017), FCC 47 CFR Part 22H (2017), FCC 47 CFR Part 24E (2017), FCC 47 CFR Part 27C (2017)
RSS-Gen Issue 4 (2014), RSS-247 Issue 2 (2017), RSS-132 Issue 3 (2013), RSS-133 Issue 6 (2013), RSS-139 Issue 3, RSS-130 Issue 1
AS/CA S042.1:2018, AS/ACIF S042.3:2005, AS/CA S042.4:2018, AS/NZS 4268:2017